I have posted about washing fleece and raw fiber before. But since my neighbor recently asked me about how I wash our raw alpaca and that I've been having a little stress about where to do it at our new place, I thought it might be a good time to write another post.
When washing fleeces, yarns, finished woolen items, or delicates, the method is essentially the same.
The only real difference between sheep's wool vs. alpaca or chiengora (or angora, cashmere, silk, etc) is that sheep's wool typically contains Lanolin and Suint.
Lanolin and Suint are often referred to as grease and there are reasons to keep them. But if you're after a non-"greasy" sheep's wool, you may need to use a scouring step or a stronger detergent in order to get the fiber fully clean. For that, I refer you to this series of posts by Deborah Robson.
If the grease has already been removed or was never present, then the process is essentially the same. The key to remember when washing natural fibers is:
heat + soap + agitation = felt
If you want felt, then increase one or all of these elements. If you don't want felt, then be careful to minimize all elements.
Let's take each elements one at a time.
Heat
I try to keep the water close to lukewarm. There is tolerance here.... but I don't want it hot, because I don't want anything to felt... and I don't want it cold, because submerging my hands into a basin of cold water doesn't feel good.
Soap
Personally, I like the wool washes because they are low sudsing, and therefore require less water. But you can use any soap you prefer. Dog shampoo is often low sudsing. Human shampoo and dishwashing liquid work well too, but will likely require more changes of clean water to remove the soap.
When I had reached the age of caring about how my woolens and delicates were cared for, I started using Woolite and handwashing garments regularly. I don't have this on hand anymore because I prefer to use the above Wool Washes, but Woolite would work too.
I recommend reading the label, then choosing the one that you prefer based on ingredients and scent.
Agitation
I put the soap in the water, then splash it around to make suds.
I submerge the item, then gently squeeze the soap and water thru. There is also some room here, but I am careful not to shake/agitate too much... I want to make sure the water and soap are thoroughly incorporated into the item, but I'm not trying to replicate a washing machine.
Time
I set a timer for 15-20 minutes, then get back to my basin when I have a few minutes to change the water.
At which time, I pull the item out of the basin and squeeze the water from the item. I don't wring.
Frequency
Typically my items require one soapy change and two-three non-soapy/clear changes. However, in the case of these hats, this is their first washing and two of them have yarn dyed in the red-to-purple family.
While the quality of dyeing these days is generally very good, you may notice that colors in this family bleed into the wash basin (there's probably a more technical word for this....exhaust?). So in this case, I did a few changes of soapy water before moving on to the clear water changes.
No comments:
Post a Comment